Let's set-up your Ventur™ case.

Follow the steps below to activate your microdevice using the Ventur™ case. To begin, you'll need your case, 4 plastic stand-offs, your 8-wire ribbon cable, a USB cord and computer, and access to the World Wide Web. Alright, let's go:

 
Step 1. Unbox your Ventur™ case and find the 4 plastic stand-offs under the lid.

Step 1. Unbox your Ventur™ case and find the 4 plastic stand-offs under the lid.

Step 2. Place each standoff in one of four Arduino® mounting holes and secure Arduino® to Ventur™ case.

Step 2. Place each standoff in one of four Arduino® mounting holes and secure Arduino® to Ventur™ case.

Step 3. Insert colored wires, like so:

Step 3. Insert colored wires, like so:

Step 4. Plug USB cord into a computer or USB wall outlet.

Step 4. Plug USB cord into a computer or USB wall outlet.

Step 5. Download the system-specific Arduino® IDE by clicking the button below - this software allows you to communicate with the Arduino® hardware inside your Ventur™ case.

Step 5. Download the system-specific Arduino® IDE by clicking the button below - this software allows you to communicate with the Arduino® hardware inside your Ventur™ case.

 

Finally, download the Neopixel® library by clicking the button below - this software helps you to control the RGB LEDs embedded in the Ventur™ case buttons.